Level Control Solenoid Valve: Service and Repair

REMOVAL
1. Front: REMOVE FRONT RIGHT WHEEL AND FENDER LINER
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
2. REMOVE FRONT HEIGHT CONTROL VALVE

HINT: At the time of installation, after installation, check for air leakage.

a. Disconnect the connector.
b. Disconnect the air tube connected to the height control compressor.
1. Remove the holder.
2. Spread the clip and pull the air tube out straight and slowly.

NOTICE: Do not get scratches or foreign particles on the O-ring, O-ring seal and flare section.

HINT: At the time of installation, please refer to the following items.

If replacing O-ring, coat it with MP grease. Push the air tube in straight to correct it until the clip makes "click" sound.
3. Remove the clip.
c. Disconnect the other 3 air tubes.
SST 09730-00010
d. Remove the 2 nuts and the front height control valve.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
e. Remove the 2 cushions and spacers.
3. REMOVE REAR HEIGHT CONTROL VALVE

HINT: At the time of installation, after installation, check for air leakage.

a. Disconnect the connector.
b. Disconnect the 3 air tubes.
SST 09730-00010
c. Remove the 2 nuts and the rear height control valve.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)

INSTALLATION
Installation is in the reverse order of removal.