Clutch Slave Cylinder: Service and Repair

REMOVAL





1. DISCONNECT CLUTCH LINE
Using SST, disconnect the clutch line. Use a container to catch the fluid.
SST 09023-00100
Torque: 15.2 Nm (155 kgf-cm, 11 ft. lbs.)
2. REMOVE 2 BOLTS AND PULL OUT RELEASE CYLINDER
Torque: 12 Nm (120 kgf-cm, 9 ft. lbs.)

DISASSEMBLY
1. PULL OUT PUSH ROD WITH BOOT





2. REMOVE PISTON WITH SPRING
Using compressed air, remove the piston and spring from the cylinder.
3. REMOVE BLEEDER PLUG AND CAP

REASSEMBLY
1. INSTALL BLEEDER PLUG AND CAP
Torque: 10.7 Nm (109 kgf-cm, 8 ft. lbs.)





2. COAT PISTON WITH LITHIUM SOAP BASE GLYCOL GREASE, AS SHOWN
3. INSTALL PISTON WITH SPRING INTO CYLINDER
4. INSTALL BOOT WITH PUSH ROD TO CYLINDER

INSTALLATION
Installation is in the reverse order of removal.