Removal and Installation

REMOVAL
1. REMOVE NO. 1 ENGINE UNDER COVER
Remove the 16 screws, clip and No. 1 engine under cover.





2. REMOVE DRIVE BELT
Using SST, loosen the drive belt tension by turning the drive belt tensioner clockwise from the bottom side, and remove the drive belt.
SST 09216-00041
3. DISCONNECT OIL PRESSURE SWITCH CONNECTOR
4. DISCONNECT RETURN HOSE
Remove the clip and disconnect the return hose.

NOTICE: Take care not to spill fluid on the drive belt and oil pressure switch connector.





5. DISCONNECT PRESSURE FEED TUBE
Remove the union bolt and gasket and disconnect the pressure feed tube.





6. REMOVE PS VANE PUMP ASSEMBLY
Remove the 2 bolts and PS vane pump assembly.

INSTALLATION





1. INSTALL PS VANE PUMP ASSEMBLY
Install the PS vane pump assembly with the 2 bolts.
Torque: 58 Nm (590 kgf-cm, 43 ft. lbs.)
2. CONNECT PRESSURE FEED TUBE
a. Install a new gasket to the pressure feed tube.





b. Connect the pressure feed tube with the union bolt.





HINT: Make sure the stopper of the pressure feed tube touches the PS vane pump body as shown in the illustration, then install the union bolt.

Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
3. CONNECT RETURN HOSE
Connect the return hose with the clip.
4. CONNECT OIL PRESSURE SWITCH CONNECTOR





5. INSTALL DRIVE BELT
Using SST, loosen the drive belt tension by tuning the drive belt tensioner clockwise from the bottom side, and install the drive belt.
SST 09216-00041
6. INSTALL NO. 1 ENGINE UNDER COVER
Install the No. 1 engine under cover with the 16 screws and clip.
7. BLEED POWER STEERING SYSTEM