Clearing Trouble Codes

NOTE: This is the only information provided by the manufacturer for Clearing Diagnostic Trouble Codes for this system.

Without hand-held tester:

Clear the DTC.




1. Using SST, connect terminals Tc and CG of DLC3.
SST 09843-18040
2. Turn the ignition switch ON.
3. Clear the DTC stored in ECU by depressing the brake pedal 8 or more times within 5 seconds.
4. Check that the warning light shows the normal code.
5. Remove the SST from the terminals of DLC3.
SST 09843-18040

HINT: The DTC stored in the ECU will be erased when the battery terminal is disconnected for the troubleshooting.

With hand-held tester:

Clear the DTC.




1. Hook up the hand-held tester to the DLC3.
2. Turn the ignition switch ON.
3. Operate the hand-held tester to erase the codes. (See hand-held tester operator's manual.)