Troubleshooting
P0133 - Oxygen Sensor Circuit Slow Response (Bank 1 Sensor 1)CIRCUIT DESCRIPTION
DTC Detecting Condition:
To obtain a high purification rate for the CO, HC and NOx components of the exhaust gas, a three-way catalytic converter is used. But for the most efficient use of the three-way catalytic converter, the air-fuel ratio must be precisely controlled so that it can be always close to the stoichiometric air-fuel ratio. The heated oxygen sensors have a the characteristic whereby its output voltage changes suddenly in the vicinity of the stoichiometric air-fuel ratio. This characteristic is used to detect the oxygen concentration in the exhaust gas and provide the ECM with feedback to control the air-fuel ratio. When the air-fuel ratio becomes LEAN, the oxygen concentration in the exhaust increases and the heated oxygen sensor informs the ECM of the LEAN condition (small electromotive force: <0.45 V). When the air-fuel ratio is RICHER than the stoichiometric air-fuel ratio the oxygen concentration in the exhaust gas is reduced and the heated oxygen sensor informs the ECM of the RICH condition (large electromotive force: > 0.45 V). The ECM judges by the electromotive force from the heated oxygen sensor whether the air-fuel ratio is RICH or LEAN and controls the injection timing accordingly. However, if a malfunction of the heated oxygen sensor causes abnormal electromotive force, the ECM becomes unable to perform accurate air-fuel ratio control. The heated oxygen sensors include a heater which heats the zirconia element. The heater is controlled by the ECM. When the intake air volume is low (the temperature of the exhaust gas is low) current flows to the heater to heat the sensor for accurate oxygen concentration detection.
HINT:
- Bank 1 refers to bank that includes cylinder No.1.
- Bank 2 refers to bank that does not include cylinder No.1.
- Sensor 1 refers to the sensor closer to the engine body.
Wiring Diagram:
CONFIRMATION DRIVING PATTERN
a. Connect the LEXUS hand-held tester to the DLC3.
b. Switch the LEXUS hand-held tester from the normal mode to the check mode.
c. Start the engine and let the engine idle for 100 seconds. or more.
d. Drive the vehicle at 40 km/h (24 mph) or more for 20 seconds. or more.
e. Idle the engine for 20 seconds. or more.
f. Idle the engine for 30 seconds.
HINT: If a malfunction exists, the MIL will light up during step (f).
NOTE:
If the conditions in this test are not strictly satisfied, a malfunction cannot be detected.
If you do not have a LEXUS hand-held tester, turn the ignition switch OFF once after performing steps (c) to (f), then perform steps (c) to (f) again.
Step 1:
Step 2 - 4:
Step 5 - 8:
INSPECTION PROCEDURE
HINT: Read freeze frame data using LEXUS hand-held tester or OBD II scan tool. Because freeze frame records the engine conditions when the malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the air-fuel ratio was lean or rich, etc. at the time of the malfunction.
CHECK FOR INTERMITTENT PROBLEMS
LEXUS hand-held tester only:
By putting the vehicle's ECM in the check mode, 1 trip detection logic is possible instead of 2 trip detection logic and sensitivity to detect open circuits is increased. This makes it easier to detect intermittent problems.
1. Clear the DTCs.
2. Set the check mode.
3. Perform a simulation test.
4. Check the connector and terminal.
5. Check the connector connection.