Transmission Position Sensor/Switch: Service and Repair
REPLACEMENT1. REMOVE BATTERY
2. REMOVE AIR CLEANER ASSY
3. REMOVE AIR CLEANER HOSE NO. 1
4. REMOVE INTAKE AIR RESONATOR SUB-ASSY
5. REMOVE ENGINE UNDER COVER NO. 2
6. DISCONNECT FLOOR SHIFT TRANSMISSION CONTROL CABLE ASSY
a. Remove the nut from the control shaft lever.
b. Disconnect the control cable from the control shaft lever.
c. Remove the clip and disconnect the control cable from the control cable bracket.
7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSY
a. Disconnect the park/neutral position switch connector.
b. Remove the nut, washer and control shaft lever.
c. Pry out the lock plate.
d. Remove the lock nut and lock plate.
e. Remove the 2 bolts and pull out the park/neutral position switch.
8. INSTALL PARK/NEUTRAL POSITION SWITCH ASSY
a. Install the park/neutral position switch to the manual valve shaft.
b. Temporarily install the 2 bolts.
c. Place the lock plate and tighten the nut.
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)
d. Temporarily install the control shaft lever.
e. Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
f. Remove the control shaft lever.
g. Align the groove with neutral basic line.
h. Hold the switch in position and tighten the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
i. Using a screwdriver, stake the nut with the lock plate.
j. Install the control shaft lever, washer and nut.
Torque: 12.7 Nm (130 kgf-cm, 9 ft. lbs.)
k. Connect the park/neutral position switch connector.
9. INSTALL FLOOR SHIFT TRANSMISSION CONTROL CABLE ASSY
a. Temporarily install the control cable to the control shaft lever with the nut.
b. Install the control cable and a new clip to the bracket.
10. AD-JUST SHIFT LEVER POSITION
11. INSPECT SHIFT LEVER POSITION
12. INSPECT PARK/NEUTRAL POSITION SWITCH ASSY
13. INSTALL ENGINE UNDER COVER NO. 2
14. INSTALL INTAKE AIR RESONATOR SUB-ASSY
15. INSTALL AIR CLEANER HOSE NO. 1
16. INSTALL AIR CLEANER ASSY
17. INSTALL BATTERY