Precaution of Height Control Sensor Replacement

PRECAUTION OF HEIGHT CONTROL SENSOR REPLACEMENT
a. Initialize the height control sensor as the following procedure.

HINT: After work that could change the vehicle height such as height control sensor removal and installation and suspension replacement, initializing would be needed before adjusting the headlamp aiming.

1. Reduce the fuel amount to 10 L (2.64 gal., 2/20 Imp.gal).
2. Unload luggage's from a vehicle as many as possible.
3. Using SST, connect terminal 12 and 16 of DLC 3 with IG switch ON.
4. Turn the headlamp dimmer switch OFF -> HEAD -> OFF.
5. Check that indicator on combination meter blinks twice and disconnect the SST from DLC3. If the indicator does not blink, work from step (1) again.