Removal and Installation
AIRBAG SENSOR REAR LHREPLACEMENT
1. PRECAUTION
2. SEPARATE BATTERY NEGATIVE TERMINAL
3. REMOVE REAR SEAT CUSHION ASSY
4. REMOVE REAR SEAT BACK ASSY
5. REMOVE AIR BAG SENSOR REAR LH
a. Disconnect the connector of the airbag sensor rear LH.
b. Remove the 2 bolts and the airbag sensor rear LH.
6. INSTALL AIR BAG SENSOR REAR LH
a. Select a suitable bolt.
b. Install the airbag sensor rear LH with the 2 bolts.
Torque:
Property class 6T: 17.5 N.m (178 kgf.cm, 13 ft.lbf)
Property class 8T: 20 N.m (200 kgf.cm, 14 ft.lbf)
c. Connect the connector of the airbag sensor rear LH.
NOTE:
- Installation of the connector is done with the sensor assembly installed. Make sure the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installation, shake the sensor assembly to check that there is no looseness.
7. INSPECT AIR BAG SENSOR REAR LH
8. INSTALL REAR SEAT BACK ASSY
9. INSTALL REAR SEAT CUSHION ASSY
10. INSPECT SRS WARNING LIGHT