Radiator: Service and Repair
Removal & Installation and Disassembly & Reassembly1. DRAIN COOLANT
2. DISCONNECT RADIATOR HOSE INLET
3. DISCONNECT RADIATOR HOSE OUTLET
4. DISCONNECT OIL COOLER INLET HOSE
5. DISCONNECT OIL COOLER OUTLET HOSE NO.2
6. REMOVE AIR CLEANER INLET ASSY
a. Remove the 3 bolts, the air cleaner inlet and air cleaner inlet No.1.
7. REMOVE RADIATOR SUPPORT UPPER
a. Remove the radiator lower air deflector.
b. Disconnect the 2 horn connector.
c. Remove the hood lock release lever cover.
d. Remove the bolt shown in the illustration.
e. Remove the 4 bolts and radiator support upper.
8. REMOVE RADIATOR ASSY
a. Disconnect the fan motor connector.
b. Remove the radiator w/ fan.
9. REMOVE RADIATOR SUPPORT CUSHION
10. REMOVE RADIATOR SUPPORT LOWER
11. REMOVE FAN ASSY, W/ MOTOR
12. INSTALL FAN ASSY, W/ MOTOR
a. Install the fan assy w/motor to the radiator.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
13. INSTALL RADIATOR SUPPORT UPPER
a. Install the radiator support upper with the 4 bolts.
Torque: 14 Nm (142 kgf-cm, 10 ft. lbs.)
14. ADJUST HOOD SUB-ASSY
15. ADD COOLANT
16. CHECK ENGINE COOLANT LEAK