Clearing Trouble Codes

NOTE: This is the only information provided by the manufacturer for Clearing Diagnostic Trouble Codes for this system.

Without hand-held tester

Clear DTC.

1. Using SST connect the terminals Tc and CG of the DLC3.
SST 09843-18040

2. Turn the ignition switch ON.




3. Clear DTC stored in ECU by depressing the brake pedal 8 or more times within 5 sec.

4. Check that the ABS warning light shows the normal code.

5. Remove the SST from the DLC3.
SST 09843-18040

HINT: Disconnecting the battery cable during repairs will not erase the DTC in the ECU.

With hand-held tester

Clear the DTC.

1. Turn the ignition switch ON.
2. Operate the hand-held tester to erase the codes.

HINT: Please refer to the hand-held tester operator's manual for further details.