Clearing Diagnostic Trouble Codes

NOTE: This is the only information provided by the manufacturer for Clearing Diagnostic Trouble Codes for this system.

Clearing Individual DTC Memory
(when clearing the memory of DTC detected in the past individually)

1. Press the preset switch "5" for 2 sec. or more while the "ECHn" is displayed in the service check mode or during the detail information mode.

HINT:
- Beep sound is given once when the DTC memory is completely cleared.
- When DTC memory is cleared, only the component code (physical address) is displayed for the target component.
- To check DTC, press the preset switch "1" and perform the service check again.

Clearance of all DTC memory
(when clearing all the memory of DTC detected in the past)

1. Start the diagnosis mode after repairing the trouble area.
2. Press the preset switch "5" for 2 sec. or more. ("CLr" is displayed at this time.)

HINT:
- Beep sound is given once when the DTC memory is completely cleared.
- When DTC memory for all the device is cleared, only the component codes (physical address) are displayed.

3. Press the preset switch "1" to perform the service check again, and check that no DTC is displayed for all the component codes (physical address).