Front Steering Knuckle: Service and Repair

REMOVAL
1. REMOVE FRONT AXLE HUB
2. REMOVE STEERING KNUCKLE
a. Remove the clip and nut.
Torque: 87 Nm (885 kgf-cm, 64 ft. lbs.)





b. Using SST, disconnect the steering knuckle and remove it from the upper ball joint.
SST 09610-20012
c. Remove the 2 bolts and steering knuckle from the lower ball joint.
Torque: 113 Nm (1,150 kgf-cm, 83 ft. lbs.)

INSTALLATION
Installation is in the reverse order of removal.

HINT: After installation, check the front wheel alignment.