Removal and Installation
Airbag Sensor Assembly:
REMOVAL
NOTE: Do not open the cover or the case of the ECU and various computers unless absolutely necessary.
(If the IC terminals are touched, the IC may be destroyed by static electricity.)
1. REMOVE THESE PARTS:
a. Finish plate
b. End Pad
c. No.1 under cover
d. Hood lock release lever
e. No.1 safety pad
f. No.2 under cover
g. Glove compartment finish plate
h. Glove compartment panel assembly
i. Front ash receptacle
j. Cluster finish panel
k. Console box carpet
l. Accessary socket
m. Accessary case
n. Lower rear console box
o. Rear console armrest
p. Console box register
q. Console box
r. No.3 console box mounting bracket
s. No.1 console box duct
2. REMOVE AIRBAG SENSOR ASSEMBLY
a. Disconnect the airbag sensor connectors.
NOTE: Remove the connectors with the sensor assembly installed.
b. Using a torx wrench, remove the 3 screws and airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
INSTALLATION
NOTE:
- Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
- Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
- Never repair a sensor in order to reuse it.
1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with 3 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
b. Connect the airbag sensor connectors.
NOTE:
- Installation of the connector is done with the sensor assembly installed. Make sure the sensor assembly is installed to the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the senor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installing , shake the sensor assembly to check that there is no looseness.
2. INSTALL THESE PARTS:
a. No.1 console box duct
b. No.3 console box mounting bracket
c. Console box
d. Console box register
e. Rear console armrest
f. Lower rear console box
g. Accessary case
h. Accessary socket
i. Console box carpet
j. Cluster finish panel
k. Front ash receptacle
l. Glove compartment panel assembly
m. Glove compartment finish plate
n. No.2 under cover
o. No.1 safety pad
p. Hood lock release lever
q. No.1 under cover
r. End Pad
s. Finish plate