Evaporative Emission Control Canister: Service and Repair
REMOVE CHARCOAL CANISTER ASSEMBLYa. Disconnect the RH rear drive shaft from the differential.
b. Remove the charcoal canister assembly.
1. Disconnect the vapor pressure sensor connector.
2. Disconnect the VSV connector for pressure switching valve.
3. Disconnect the purge line hose, EVAP line hose and air inlet line from the charcoal canister.
4. Disconnect the vent line hose from the charcoal canister.
Push the connector deep inside, pinch portion A, and pull out the connector.
5. Disconnect the air drain hose from the canister tank.
6. Remove the 3 nuts and the charcoal canister assembly.
INSTALL CHARCOAL CANISTER ASSEMBLY
a. Install the charcoal canister assembly.
b. Connect the RH rear drive shaft to the differential.