Component Tests

SPEED SENSOR SIGNAL CHECK




a. In case of not using LEXUS hand-held tester:
Check the speed sensor signal.
1. Turn the ignition switch OFF.
2. Using SST, connect terminals Ts and E1 of the DLC1 or terminals Ts and CG of the DLC3.
SST 09843-18020 or 09843-18040
3. Start the engine.




4. Check that the ABS warning light blinks.

HINT: If the ABS warning light does not blink, inspect the ABS warning light circuit.

5. Drive the vehicle straight forward.
Drive the vehicle faster than 45 km/h (28 mph) for several seconds.
6. Stop the vehicle.
7. Using SST, connect terminals Tc and E1 of the DLC1, or terminals Tc and CG of the DLC3.
SST 09843-18020 or 09843-18040
8. Read the number of blinks of the ABS warning light.






HINT:
- See the list of DTC list shown.
- If every sensor is normal, the normal code is output (A cycle of 0.25 seconds ON and 0.25 seconds OFF is repeated).
- If 2 or more malfunctions are indicated simultaneously, the lowest numbered code will be displayed first.

9. After doing the check, disconnect the SST from terminals Ts and E1 Tc and E1 of the DLC1, or terminals Ts and CG, Tc and CG of the DLC3, and turn the ignition switch OFF.
SST 09843-18020 or 09843-18040




b. In case of using LEXUS hand-held tester:
Check the speed sensor signal.
1. Connect the LEXUS hand-held tester to the DLC3.
2. Do step (3) to (6).
3. Read the DTC by following the prompts on the tester screen.
Please refer to the LEXUS hand-held tester operator's manual for further details.

C1271/71 - C1278/78:

DTC of speed sensor check function: