Transmission Speed Sensor: Service and Repair

ON-VEHICLE REPAIR

NOTICE: When working with FIPG material, you must observe the following items.
- Using a razor blade and gasket scraper, remove all the old FIPG material from the gasket surfaces.
- Thoroughly clean all components to remove all the loose material.
- Clean both sealing surfaces with a non-residue solvent.
- Apply FIPG in an approximately 1 mm (0.04 inch) wide bead along the sealing surface.
- Parts must be assembled within 10 minutes of application. Otherwise, the FIPG material must be removed and reapplied.

1. RAISE VEHICLE AND POSITION PAN TO CATCH ANY FLUID THAT MAY DRIP
2. REMOVE PROPELLER SHAFT
3. REMOVE VEHICLE SPEED SENSOR





4. JACK UP TRANSMISSION SLIGHTLY
Securely support the transmission on a transmission jack. Lift the transmission slightly from the rear support member.





5. REMOVE REAR SUPPORT MEMBER
a. Remove the 4 nuts.
b. Remove the 4 bolts and support member.





6. REMOVE TRANSMISSION MOUNTING BRACKET
Remove the 4 bolts and bracket from the transmission.





7. REMOVE EXTENSION HOUSING
Remove the 6 bolts. If necessary, tap the extension housing with a plastic hammer or block of wood to loosen it.





8. REMOVE SENSOR ROTOR
a. Using a snap ring expander, remove the snap ring.
b. Remove the sensor rotor and key.
9. INSTALL SENSOR ROTOR AND KEY
a. Install the key and sensor rotor.
b. Using a snap ring expander, install a new snap ring.





10. INSTALL EXTENSION HOUSING
a. Apply FIPG to the extension housing.
FIPG: Part No. 08826-00090, THREE BOND 1281 or equivalent
b. Install the 6 bolts.

HINT:
- Coat the thread of the all bolts with sealant.
Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
- The 2 lower bolts are shorter.
Torque: 34 Nm (345 kgf-cm, 25 ft. lbs.)

11. INSTALL TRANSMISSION MOUNTING BRACKET
Install the bracket and 4 bolts to the transmission.
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)
12. INSTALL REAR SUPPORT MEMBER
a. Install the support member and 4 bolts.
Torque: 25 Nm (260 kgf-cm, 19 ft. lbs.)
b. Install the 4 nuts.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
13. REMOVE JACK
14. INSTALL VEHICLE SPEED SENSOR
15. INSTALL PROPELLER SHAFT
16. FILL ATF AND CHECK FLUID LEVEL