Impact Sensor: Service and Repair

DISCONNECTION
a. With holding both flank sides of the outer, slide the outer to the direction shown by an arrow.
b. Lock of the connectors is released, then disconnect the connectors.

HINT: Make sure to hold both flank sides of the outer. If holding the top and bottom sides, it will obstruct disconnection.




CONNECTION
a. Align the male connector (of the side of sensor) and female connector in same direction as shown in the illustration and fit in them without rubbing.
b. As they are fitted in, the outer slides rearward. Press it until the outer returns to its original position again.
If fitting stops on the half way, connectors will separate.
c. Make sure to insert until they are locked. After fitting in, pull them lightly to check that they are locked. (When locked, make sure that the outer returns to its original position and sound at the time of fitting in can be heard.)

HINT:
- Do not fit in with holding the outer.
- When fitting in, the outer slides. Do not touch it.