Rear

REPLACEMENT
1. REMOVE REAR WHEEL
2. REMOVE BRAKE CALIPER AND DISC
a. Remove the 2 bolts and brake caliper.
b. Support the brake caliper securely.
c. Place matchmarks on the disc and axle hub.
d. Remove the 2 screws and disc.

Fig. 50 Removing Lug Bolt:

3. REMOVE HUB BOLT
Using SST, remove the hub bolt.
SST 09628-10011

Fig. 51 Installing Lug Bolt:

4. INSTALL HUB BOLT
Install washer and nut to the hub bolt as shown in the illustration, and install the hub bolt with torquing the nut.
5. INSTALL DISC AND BRAKE CALIPER
a. Align the matchmarks on the disc and axle hub.
b. Install the brake disc and 2 screws.
Torque: 5.0 Nm (55 kgf-cm, 48 inch lbs.)
c. Install the brake caliper and 2 bolts.
Torque: 104 Nm (1,065 kgf-cm, 77 ft. lbs.)
6. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)