Speed Sensor, Front

REMOVAL





1. DISCONNECT CONNECTOR
a. Remove the front fender moulding and fender liner.
b. Disconnect the speed sensor connector.





2. REMOVE SPEED SENSOR
a. Remove the 3 clamp bolts holding the sensor harness to the body and steering knuckle.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
b. Right wheel: Disconnect the pad wear indicator connector from the speed sensor wire harness.
c. Remove the speed sensor from the steering knuckle.
Torque: 7.8 Nm (80 kgf-cm, 69 inch lbs.)

INSTALLATION
Installation is in the reverse order of removal.
AFTER INSTALLATION, CHECK SPEED SENSOR SIGNAL