Rear Vertical Motor

INSPECT REAR VERTICAL MOTOR OPERATION
A. Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, and check that the motor turns clockwise.
B. Reverse the polarity, and check that the motor turns counterclockwise.

If operation is not as specified, replace the motor.

Driver's seat:
INSPECT REAR VERTICAL MOTOR PTC THERMISTOR OPERATION





A. Connect the positive (+) lead from the battery to terminal 2, the positive (+) lead from the ammeter to terminal 1 and the negative (-) lead to battery negative (-) terminal, then move the rear edge of seat cushion to the highest position.
B. Continue to apply voltage, and check that the current changes to less than 1 ampere with 4 to 90 seconds





C. Disconnect the leads from terminals.
D. Approximately 60 seconds later, connect the positive (+) lead from battery to terminal 1 and the negative (-) lead to terminal 2, and check that the seat cushion begins to descend.

If operation is not as specified, replace the motor.