Front Vertical Motor

INSPECT FRONT VERTICAL MOTOR OPERATION
A. Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1 and check that the motor turns clockwise.
B. Reverse the polarity and check that the motor turns counterclockwise.

If operation is not as specified, replace the motor.

Driver's Seat:
INSPECT FRONT VERTICAL MOTOR PTC THERMISTOR OPERATION





A. Connect the positive (+) lead from the battery to terminal 1, the positive (+) lead from the ammeter to terminal 2 and the negative (-) lead to battery negative (-) terminal, then move the front edge of seat cushion to the highest position.
B. Continue to apply voltage, and check the current changes to less than 1 ampere with 4 to 90 seconds.





C. Disconnect the leads from terminals.
D. Approximately 60 seconds later, connect the positive (+) lead from battery to terminal 2 and the negative (-) lead to terminal 1, and check that the seat cushion begins to descend.

If operation is not as specified, replace the motor.