Air Inlet, Outlet, and Mix Servomotors

REMOVAL
Air Inlet, Outlet, and Mix Servomotors

1. REMOVE AIR INLET SERVOMOTOR
a. Remove these parts:
1. Front door scuff plate RH
2. Cowl side trim RH
3. No.2 under cover
4. Glove compartment door
5. Glove compartment panel




b. Disconnect the wire harness.




c. Remove the bracket.
1. Disconnect wire harness clamp.
2. Remove the 2 bolts and bracket.




d. Remove the air inlet servomotor.
1. Disconnect the connector.
2. Remove the 3 screws and servomotor.

2. REMOVE AIR MIX SERVOMOTOR (Driver Side)
a. Remove these parts:
1. No.1 undercover
2. No.1 safety pad




b. Remove the air mix servomotor.
1. Disconnect the connector.
2. Remove the 3 screws and servomotor.
3. REMOVE AIR MIX SERVOMOTOR (Passenger Side)

a. Remove heater radiator.




b. Remove the air mix servomotor.
1. Disconnect the connector.
2. Remove the 3 screws and servomotor.

4. REMOVE AIR OUTLET SERVOMOTOR
a. Remove these parts:
1. No.2 under cover
2. Glove compartment door
3. Glove compartment panel




b. Remove the air duct.
Remove the 3 screws and air duct.




c. Remove air outlet servomotor.
1. Disconnect the connector.
2. Remove the 2 screws and servomotor.

INSTALLATION
Installation is in the reverse order of removal.