Steering Knuckle Set Bolts - Replaced by Camber Bolts
SU001-97SUSPENSION
April 11, 1997
Title:
CAMBER ADJUSTING BOLTS
Models:
ES 300
Introduction
To increase camber adjusting capability the steering knuckle set bolts can be replaced with new camber adjusting bolts. These new camber adjusting bolts allow for greater movement between the steering knuckle and shock absorber assembly.
NOTE: Vehicles which are out of alignment specifications due to a collision or worn out parts, should be inspected for damage and/or worn out parts before performing an alignment.
Affected Vehicles
^ ES 300s.
Adjustment Procedures
To change camber, install the adjusting bolt in the lower steering knuckle mounting hole. If a camber change greater than 0.75° (45') is required, camber bolts can be installed in both upper and lower steering knuckle holes for camber changes up to 1.50° (1°30'). See Camber Adjusting Bolt Table for model, part number and bolt selection.
Camber Adjusting Table
Torque Specifications
NOTE: Camber adjusting bolt values, bolt identification and part number information for current production models can also be found in the SUSPENSION - WHEEL ALIGNMENT section of the applicable 1996 or later repair manuals.
Warranty Information
NOTE: No Warranty Applicable.