Removal and Installation

COMPONENTS

REMOVAL
1. REMOVE THESE PARTS:
a. Cowl side trim RH
b. Front door scuff plate RH
c. No.2 instrument panel under cover
d. Lower panel
e. Finish upper panel
f. CD change assembly
g. Audio amplifier
h. ECM

2. REMOVE CONNECTOR BRACKET SET SCREWS
3. REMOVE BLOWER UNIT
a. Disconnect the connectors from blower unit.
b. Disconnect the wire harness clamps.
c. Disconnect the evaporator temperature sensor connector clamp.
d. Remove the 2 screws, bolt and nut, then remove the blower unit.

INSTALLATION
Installation is in the reverse order of removal.