Brake Pedal Height

CHECK PEDAL HEIGHT
Pedal height from asphalt sheet: 152.0 - 162.0 mm (5.984 - 6.378 inch)
IF NECESSARY, ADJUST PEDAL HEIGHT
a. Remove the No. 1 lower panel and lower LH panel.
b. Disconnect the connector from the stop light switch.
c. Loosen the stop light switch lock nut and remove the stop light switch.
d. Loosen the push rod lock nut.
e. Adjust the pedal height by turning the pedal push rod.
f. Tighten the push rod lock nut.
Torque: 25 Nm (260 kgf-cm, 19 ft. lbs.)
g. Install the stop light switch.
h. Push the brake pedal in 5 - 15 mm (0.20 - 0.59 inch), turn the stop light switch to lock the nut in a position where the stop light goes off.
i. Connect the connector to the stop light switch.
j. After installation, push the brake pedal in 5 - 15 mm (0.20 - 0.59 inch), check that stop light lights up.
k. After adjusting the pedal height, check the pedal freeplay.
l. Install the lower LH panel and No. 1 lower panel.