Front Vertical Motor

INSPECT FRONT VERTICAL MOTOR OPERATION
A. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, check that the motor turns counterclockwise.
B. Reverse the polarity, check that the motor turns clockwise.
If operation is not as specified, replace the seat adjuster.

INSPECT FRONT VERTICAL MOTOR PTC THERMISTOR OPERATION





A. Connect the positive (+) lead from the battery to terminal 1, the positive (+) lead from the ammeter to terminal 2 and the negative (-) lead to the battery negative (-) terminal, then move the seat cushion to the highest position.
B. Continue to apply voltage, check that the current changes to less than 1 ampere within 4 to 90 seconds.





C. Disconnect the leads from the terminals.
D. Approximately 60 seconds later, connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, check that the seat cushion begins to descend.
If operation is not as specified, replace the seat adjuster.