Removal

NOTICE:
If the wiring connector of the SRS is disconnected and the ignition switch is at ON or ACC position, DTCs will be recorded.
Never use the airbag parts from another vehicle. When replacing parts, replace with new parts.






1. DISCONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR
a. Open the glove compartment door.
b. Using a screwdriver, remove the glove compartment door finish plate from the glove compartment.






c. Remove the connector form the glove compartment door finish plate.
d. Disconnect the airbag connector.

NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

2. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER.
3. REMOVE GLOVE COMPARTMENT ASSEMBLY.
4. REMOVE LOWER FINISH PANEL RH.
5. REMOVE NO. 4 HEATER TO REGISTER DUCT.
6. REMOVE GLOVE COMPARTMENT DOOR LOCK MOUNTING BRACKET.






7. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
a. Remove the 3 bolts and 2 nuts.
b. Pull out the front passenger airbag assembly from the instrument panel.

CAUTION:
- Do not store the front passenger airbag assemble with the airbag deployment side facing downward.
- Never disassemble the front passenger airbag assembly.