Brake Master Cylinder: Adjustments

ADJUSTMENT





ADJUST LENGTH OF BOOSTER PUSH ROD
a. Install the new gasket on the master cylinder.
b. Set the SST on the gasket, and lower the pin until its tip slightly touches the piston.
SST 09737 - 00010
c. Turn the SST upside down, and set it on the booster.
SST 09737 - 00010
d. Measure the clearance between the booster push rod and pin head (SST).
Clearance: 0 mm (0 inch)





e. Adjust the booster push rod length until the push rod slightly touches the pin head.

HINT: When adjusting the push rod, depress the brake pedal enough so that the push rod sticks out.