Level Control Solenoid Valve: Service and Repair

REMOVAL
1. FRONT
REMOVE FRONT RIGHT WHEEL AND FENDER LINER

Torque: 103 Nm (1,050 kgf.cm, 76 ft.lbs. )

2. REAR:
REMOVE LUGGAGE COMPARTMENT TRIM FRONT COVER
3. REMOVE HEIGHT CONTROL VALVE

HINT: At the time of installation, after installation, check for air leakage.

a. Remove the connector.
b. Remove the air tube.
1. Remove the holder.
2. Spread the clip and pull the air tube out straight and slowly.

NOTICE: Do not get scratches or foreign particles on the O-ring, O-ring seal and flare section.

HINT: At the time of installation, please refer to the following items.
- If replacing O-ring, coat it with MP grease.
- Push the air tube in straight to correct it until the clip makes "click" sound.

3. Remove the clip.
c. Remove the 2 nuts and the height control valve.

Torque: 5.4 Nm (55 kgf.cm, 48 inch lbs.)

4. REMOVE BUSHING, CUSHION AND SPACER

INSTALLATION
Installation is in the reverse order of removal.