Compressor/Pump: Service and Repair

REMOVAL
1. REMOVE FRONT RIGHT WHEEL

Torque: 103 Nm (1,050 kgf.cm, 76 ft.lbs. )

2. REMOVE FRONT RIGHT FENDER LINER
3. REMOVE HEIGHT CONTROL COMPRESSOR AND DRYER

HINT: At the time of installation, after installation, check for air leakage.

a. Remove the connector.
b. Remove the air tube.
1. Remove the holder.
2. Spread the clip and pull the air tube out straight and slowly.

NOTICE: Do not get scratches or foreign particles on the O-ring, O-ring seal and flare section.

HINT: At the time of installation, please refer to the following items.
- If replacing the O-ring, coat it with MP grease.
- Push the air tube in straight to connect it until the clip makes "click" sound.

3. Remove the clip.





c. Remove the 4 bolts and the height control compressor and dryer with the bracket.

Torque: 19 Nm (195 kgf.cm, 14 ft.lbs. )





d. Remove the 3 bolts and the bracket from the height control compressor.

Torque: 5.9 Nm (60 kgf.cm, 52 inch lbs.)

e. Remove the bolt and the dryer from the height control compressor.

Torque: 6.4 Nm (65 kgf.cm, 56 inch lbs.)

NOTICE: Slowly pull out or push in the dryer along the dryer axis and do not damage the O-ring on the compressor side.

HINT: At the time of installation, if replacing the O-ring, coat it with MP grease.

4. REMOVE BUSHING AND SPACER

INSTALLATION
Installation is in the reverse order of removal.