Removal

NOTE:
If the wiring connector of the SRS is disconnected and the ignition switch is at ON or ACC position, DTCs will be recorded.
Never use the airbag parts from another vehicle. When replacing parts, replace with new parts.






1. DISCONNECT AIRBAG CONNECTOR
a. Remove the glove compartment door finish plate inside the instrument panel box.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.






b. Pull up the connector.
c. Disconnect the front passenger airbag connector.

2. REMOVE INSTRUMENT PANEL






3. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
a. Remove the No.2 side defroster nozzle.
b. Remove the 5 nuts then remove the front passenger airbag assembly.

CAUTION:
- Do not store the front passenger airbag assembly with the airbag deployment side facing downward.
- Never disassemble the front passenger airbag assembly.