Parking Brake Pedal: Service and Repair

REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE, END PAD, NO. 1 UNDER COVER, NO. 1 SAFETY PAD AND NO. 7 HEATER TO REGISTER DUCT
2. REMOVE PARKING BRAKE PEDAL ASSEMBLY
a. Disconnect the parking brake switch connector.
b. Remove the 2 bolts, and disconnect the parking brake release lever from the safety pad.

Torque: 5.4 Nm (55 kgf.cm, 48 inch lbs.)

c. Remove the lock nut and the adjusting nut from the parking brake wire.
d. Remove the parking brake wire.
e. Remove the 2 bolts, 2 nuts and parking brake pedal assembly.

Torque: 13 Nm (130 kgf.cm, 9 ft. lbs.)

3. REMOVE PARKING BRAKE SWITCH
Remove the screw and parking brake switch from the parking brake pedal assembly.


INSTALLATION
Installation is in the reverse order of removal.

HINT: After the installation, check and adjust parking brake pedal travel.