Removal

NOTE:
- If the wiring connector of the SRS is disconnected with the ignition switch in ON or ACC position, DTCs will be recorded.
- Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
- Never reuse the sensor involved in a collision when the SRS has deployed.
- Never repair a sensor in order to reuse it.

1. REMOVE LH FRONT AIRBAG SENSOR






a. Remove the 2 bolts and J/B cover.






b. Remove the bolt and 2 nuts.
c. Disconnect the connectors and hose, then remove the J/B box.






d. Disconnect the connector, then remove the bolt, nut and sensor.

2. REMOVE RH FRONT AIRBAG SENSOR






a. Remove the bolt and No.1 air cleaner inlet.






b. Disconnect the connector and inlet hose, then remove the 3 bolts and air cleaner.






d. Disconnect the connector, then remove the bolt, nut and sensor.