Receiver Dryer: Service and Repair

REPLACE DRYER FROM MODULATOR




a. Using a hexagon wrench (10 mm, 0.39 in.), remove the cap from the modulator.
b. Remove the filter from the modulator.




c. Using pliers, remove the dryer.




d. Insert a new dryer into the modulator.

NOTE:
- Do not remove the dryer from a vinyl bag until inserting it into the modulator.
- Install the dryer with its 2 layered part faced upward to the modulator.




e. Insert the filter into the modulator.

NOTE: Install the filter with its protrusion faced downward to the modulator.




f. Install the cap to the modulator.
1. Apply compressor oil to the O-rings and screw part of the cap.
Compressor oil: ND-OIL 8 or equivalent
2. Using a hexagon wrench (10 mm, 0.39 in.), install the caps.
Torque: 12.3 N.m (125 kgf.cm, 9 ft.lbf)