Installation

1. INSTALL FRONT AIRBAG SENSOR LH AND RH
a. Install the front airbag sensors with the arrow on the sensor facing toward the front of the vehicle.

Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)

NOTE:
- Connection of the connector is done after the sensor has been installed.
- Make sure the sensor is installed with the specified torque.
- If the sensor has been dropped, or there are cracks, dents or other defects in the case, brackets or connector, replace the removed sensor with a new one.
- The front sensor is equipped with an electrical connection check mechanism. Be sure to lock this mechanism securely when connecting the connector. If the connector is not securely locked, a malfunction code will be detected by the diagnostic system.

b. Connect the front airbag sensor connectors.

2. INSTALL HEADLIGHT LH AND RH
a. Connect the connectors, then install the headlights with the 2 bolts and 4 nuts.
b. Connect the connectors, then install the turn signal light with the 2 screws.
c. Install the radiator support upper seal with the 8 clips.