Removal

NOTE:
- If the wiring connector of the SRS is disconnected with the ignition switch at ON or ACC position, DTCs will be recorded.
- Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
- Never reuse the sensor involved in a collision when the SRS has deployed.
- Never repair a sensor in order to reuse it.

1. REMOVE HEADLIGHT LH AND RH
a. Remove the 8 clips and radiator support upper seal.
b. Remove the 2 screws and turn signal lights, then disconnect the connectors.
c. Remove the 2 bolts, 4 nuts and headlights, then disconnect the connectors.




2. REMOVE FRONT AIRBAG SENSOR LH
a. Disconnect the connector.

NOTE: Disconnect the connector with front airbag sensor installed.

b. Remove the 2 bolts and front airbag sensor LH.




3. REMOVE FRONT AIRBAG SENSOR RH
a. Disconnect the connector.

NOTE: Disconnect the connector with front airbag sensor installed.

b. Remove the 2 bolts and front airbag sensor RH.