Installation

INSTALLATION

NOTE:
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
Never repair a sensor in order to reuse it.

Airbag Sensor Assembly:

1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with 3 screws.

Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)

Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)

b. Connect the airbag sensor connectors.

NOTE:
- Installation of the connector is done after the sensor assembly has been installed.
- Make sure the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the senor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installing , shake the sensor assembly to check that there is no looseness.

2. INSTALL REMOVED PARTS
a. Floor carpet bracket RH
b. Floor carpet bracket LH