Camshaft Position Sensor: Service and Repair
REPLACEMENT1. REMOVE V-BANK COVER
a. Using a 5 mm hexagon wrench, remove the 3 cap nuts.
b. Loosen the V-bank cover fastener counterclockwise.
c. Remove the V-bank cover.
2. REMOVE AIR CLEANER HOSE WITH RESONATOR
3. REMOVE CAMSHAFT POSITION SENSORS
a. Disconnect the 2 camshaft position sensor connectors.
b. Remove the bolt and camshaft position sensor. Remove the 2 camshaft position sensors.
c. Remove the O-ring from the camshaft position sensors.
4. REINSTALL NEW CAMSHAFT POSITION SENSORS
a. Install new O-ring to new camshaft position sensors.
b. Install the camshaft position sensor with the bolt. Install the 2 camshaft position sensors.
Torque: 8 N.m (80 kgf.cm, 69 in.lbf)
c. Connect the 2 camshaft position sensor connectors.
5. REINSTALL AIR CLEANER HOSE WITH RESONATOR
6. REINSTALL V-BANK COVER
a. Using 5 mm hexagon wrench, install the V-bank cover with the 3 cap nuts.
b. Press down the V-bank cover fastener.