Seat Belt Reminder Buzzer: Testing and Inspection

INSPECT INTEGRATION RELAY SEAT BELT WARNING SYSTEM OPERATION




a. Connect the positive (+) lead from the battery to terminals 1 and 7.
b. Connect the terminal 7 to terminal 9 through the 3.4W test bulb.
c. Connect the negative (-) lead from the battery to terminal 10.
d. Check that the bulb lights and the buzzer sounds for 4 to 8 seconds.
e. Return to step a.and operate the chime again.




f. Connect the negative (-) lead from the battery to terminal 8.
g. Check that the buzzer stops sounding.

HINT: Check the buzzer within a period of 4 to 8 seconds.
If operation is not as specified, replace the relay.

Seat belt warning
INSPECT INTEGRATION RELAY CIRCUIT







Remove the relay from the junction block No.1 and inspect the connectors on the junction block side.
If the circuit is as specified, try to replace the relay with a new one.
If the circuit is not as specified, inspect the circuits connected to other parts.