Brake Master Cylinder: Adjustments

ADJUST LENGTH OF BOOSTER PUSH ROD
a. Install a new gasket on the master cylinder.





b. Set the SST on the gasket, and lower the pin until its tip slightly touches the piston.
SST 09737 - 00010





c. Turn the SST upside down, and set it on the booster.
SST 09737 - 00010
d. Measure the clearance between the booster push rod and pin head (SST).

Clearance: 0 mm (0 inch)

e. Adjust the booster push rod length until the push rod lightly touches the pin head.