Hydraulic Test

HYDRAULIC TEST

(a) Measure the line pressure.

NOTICE:
- Do the test normal operation fluid temperature 50-80 °C (122- 176 °F).
- The line pressure test should always be carried out in pairs. One technician should observe the conditions of wheels or wheel stoppers outside the vehicle while the other is doing the test.
- Be careful to prevent SRS hose from interfering with the exhaust pipe.

(1) Warm-up the ATF.
(2) Remove the test plug on the transmission case front left side and connect SST. SST 0999200094
(3) Fully apply the parking brake and chock the 4 wheels.
(4) Start the engine and check idling speed.
(5) Keep your left foot pressed firmly on the brake pedal and shift into 0 position.
(6) Measure the line pressure when the engine is idling.
(7) Depress accelerator pedal all the way down. Quickly read the highest line pressure when engine speed reaches stall speed.
(8) In the same manner, do the test in R position.





Specified line pressure:

If the measured pressures are not up to specified values, recheck the throttle cable adjustment and refer.





Evaluation