Rear
REPLACEMENT1. Remove rear wheel.
2. Remove rear brake caliper and brake disc.
a. Remove the 2 bolts and brake caliper.
b. Support the brake caliper securely.
c. Place matchmarks on the disc and axle hub.
d. Remove the 2 screws and disc.
Fig. 50 Removing Lug Bolt:
3. Remove hub bolt.
Using Special Service Tool (SST) 09628 - 10011 or equivalent, remove the hub bolt.
Fig. 51 Installing Lug Bolt:
4. Install hub bolt.
Install washer and nut to the hub bolt as shown in the illustration, and install the hub bolt with torquing the nut.
5. Install rear brake disc and brake caliper.
a. Align the matchmarks on the disc and axle hub.
b. Install the brake disc and 2 screws.
Torque: 5.0 Nm (48 inch lbs.)
c. Install the brake caliper and 2 bolt.
Torque: 104 Nm (77 ft. lbs.)
6. Install rear wheel.
Torque: 103 Nm (76 ft. lbs.)