Component Inspection

INSPECT MIRROR MOTOR OPERATION
w/o Driving position memory:




a. Connect the positive (+) lead from the battery to terminal 6 and negative (-) lead to terminal 5, then check that the mirror turns to left side.
b. Reverse the polarity and check that the mirror turns to right side.




c. Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, then check that the mirror turns upward.
d. Reverse the polarity and check that the mirror turns downward.

INSPECT MIRROR MOTOR OPERATION
w/ Driving position memory:




a. Connect the positive (+) lead from the battery to terminal 11 and negative (-) lead to terminal 12, then check that the mirror turns to left side.
b. Reverse the polarity and check that the mirror turns to right side.




c. Connect the positive (+) lead from the battery to terminal 11 and negative (-) lead to terminal 10, then check that the mirror turns upward.
d. Reverse the polarity and check that the mirror turns downward.

INSPECT MIRROR POSITION SENSORS

HINT: Strip off the vinyl tape of the connector and remove terminals 6, 7, 10, 11, 12, 13 and 14 from the connector housing.




a. Connect a series of three 1.5 V dry cell batteries.
b. Connect the positive (+) lead from the dry cell batteries to terminal 7 and the negative (-) lead to terminal 6.
c. Connect the positive (+) lead from the voltmeter to terminal 13 and the negative (-) lead to terminal 6.







d. Apply battery positive voltage to terminals 10 and 11, then check that the voltage gradually changes according to the table below while the mirror moves between the uppermost position and lowermost position.
If voltage value is not as specified, replace the motor assembly.










e. Disconnect the 4 leads of the battery and voltmeter.
f. Connect the positive (+) lead from the voltmeter to terminal 14 and negative (-) lead to terminal 6.
g. Apply battery positive voltage to terminals 11 and 12, then inspect that the voltage gradually changes according to the table below while the mirror moves between the leftmost position and right-most position.
If voltage value is not as specified, replace the motor assembly.