Fog/Driving Lamp Switch: Testing and Inspection

INSPECT FOG LIGHT SWITCH CONTINUITY
If continuity is not as specified, replace the switch.







INSPECT FOG LIGHT SWITCH CIRCUIT
Connector disconnected:
Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown.
If circuit is not as specified, inspect the wire harness.







INSPECT FOG LIGHT SWITCH CIRCUIT
Connector connected:
Connect the wire harness side connector to the light control an dimmer switch and inspect the connector from the back side, as shown.
If circuit is not as specified, inspect the wire harness.