Parking Brake Shoe: Service and Repair

REMOVAL
1. Remove these parts:
a. No. 1 under panel.
b. End pad.
c. Finish panel.
d. No.1 safety pad.
e. No.2 heater to register duct.
f. Scuff plate.
2. Remove parking brake pedal assembly.
a. Disconnect the parking brake switch connector.
b. Remove the 2 bolts, and disconnect the parking brake release lever from the safety pad.
Torque: 5.4 Nm (48 inch lbs.)
c. Remove the lock nut and the adjusting nut from the parking brake wire.
d. Remove the parking brake wire.
e. Remove the 2 bolts, 2 nuts and parking brake pedal assembly.
Torque: 13 Nm (9 ft. lbs.)
3. Remove parking brake switch.

INSTALLATION
Installation is in the reverse order of removal.