Disassembly

1. Using a screwdriver, remove the dust deflector.
2. Remove the lower ball joint, following these procedures.
a. Remove the cotter pin and nut.





b. Using the 09628-62011 SST, remove the lower ball joint.
3. Remove the axle hub by following these procedures.





a. Using the 09520-00031 SST, remove the axle hub.





b. Using the 09950 - 00020, 09950-0010 (09951-00400), 09950 - 70010 (09951 -07100) SST and a press, remove the inner race (outside) from the axle hub.
4. Using a (T30) torx wrench , remove the four bolts and dust cover.
5. Remove the bearing from steering knuckle, performing the following.
a. Using snap ring pliers, remove the snap ring.
b. Place the inner race on the outside of the bearing.





c. Using the 09310 - 35010, 09527-17011 SST and a press, remove the bearing.