Assembly

1. Using the 09608-32010 SST and a press, install a new bearing to the steering knuckle, and, using snap ring pliers, install a new snap ring.
2. Install the dust cover then place the dust cover and using a (T30) torx wrench, tighten the four bolts to 8.3 Nm (74 inch lbs.).





3. Using the 09310-35010, 09608-32010 SST and a press, install the front axle hub.
4. Install the lower ball joint by doing these steps.
a. Install the lower ball joint and tighten the nut to 123 Nm (90 ft. lbs.).
b. Install a new cotter pin.





5. Using the 09316-60011 (09316 - 00011, 09316 - 00041), 09608-32010 SST and a hammer, install a new dust deflector.

NOTE: Align the holes for the ABS speed sensor in the dust deflector and steering knuckle.