Power Tilt and Telescopic Steering Column
SERVICE SPECIFICATIONSPawl Stopper
Mark:
1 or A 12.68 - 12.74 mm (0.4992 - 0.5016 inch)
2 or B 12.61 - 12.67 mm (0.4965 - 0.4988 inch)
3 or C 12.54 - 12.60 mm (0.4937 - 0.4961 inch)
4 or D 12.47 - 12.53 mm (0.4909 - 0.4933 inch)
5 or E 12.40 - 12.46 mm (0.4882 - 0.4906 inch)
6 or F 12.33 - 12.39 mm (0.4854 - 0.4878 inch)
7 or G 12.26 - 12.32 mm (0.4827 - 0.4850 inch)
TIGHTENING SPECIFICATIONS
Column Assembly Set Bolt 25 Nm (19 ft. lbs.)
Connector Bracket To
Telescopic Steering Gear Assembly 4.9 Nm (43 inch lbs.)
Intermediate Shaft To Control Valve Shaft 35 Nm (26 ft. lbs.)
Sliding Yoke To Intermediate Shaft 35 Nm (26 ft. lbs.)
Support Stopper Bolt To Stopper Nut 3.0 Nm (27 inch lbs.)
Telescopic Adjusting
Screw 6.9 Nm (61 inch lbs.)
Screw Lock Nut 26 (31) Nm (19 (23) ft. lbs.)
Telescopic Sensor Plate To
Telescopic Steering Gear Assembly 4.9 Nm (43 inch lbs.)
Tilt Steering Housing Support To
Tilt Steering Gear Assembly 13 Nm (9 ft. lbs.)
NOTE: ( ) for use without Special Service Tool (SST).