Manual Tilt and Telescopic Steering Column

SERVICE SPECIFICATIONS
Pawl Stopper
Mark:
1 or A 12.68 - 12.74 mm (0.4992 - 0.5016 inch)
2 or B 12.61 - 12.67 mm (0.4965 - 0.4988 inch)
3 or C 12.54 - 12.60 mm (0.4937 - 0.4961 inch)
4 or D 12.47 - 12.53 mm (0.4909 - 0.4933 inch)
5 or E 12.40 - 12.46 mm (0.4882 - 0.4906 inch)
6 or F 12.33 - 12.39 mm (0.4854 - 0.4878 inch)
7 or G 12.26 - 12.32 mm (0.4827 - 0.4850 inch)

TIGHTENING SPECIFICATIONS
Column Assembly Set Bolt 25 Nm (19 ft. lbs.)
Column Tube Stopper Bolt 19 Nm (14 ft. lbs.)
Compression Spring Set Bolt (Torx Bolt) 7.8 Nm (69 inch lbs.)
Connector Bracket Set Bolt 4.9 Nm (43 inch lbs.)
Intermediate Shaft To Control Valve Shaft 35 Nm (26 ft. lbs.)
Sliding Yoke To Intermediate Shaft 35 Nm (26 ft. lbs.)
Telescopic Lever Serration Attachment Set Nut 13 Nm (9 ft. lbs.)
Telescopic Lever To Breakaway Bracket 25 Nm (19 ft. lbs.)
Tilt Lever Assembly To Column Upper Tube 2.9 Nm (26 inch lbs.)
Tilt Lever Retainer Set Nut 15 Nm (11 ft. lbs.)
Tilt Memory Bolt To
Column Lower Tube 6.4 Nm (56 inch lbs.)
Nut 5.9 Nm (52 inch lbs.)
Tilt Pawl Set Nut 5.9 Nm (52 inch lbs.)