ABS & TRAC Actuator Bleeding

CAUTION:
^ When repairing the brake master cylinder or ABS & TRAC actuator, bleed the air out of the ABS & TRAC actuator.
^ Do not let brake fluid remain on a painted surface. Wash it off immediately.

NOTE: If any work is done on the brake system or if air is suspected in the brake lines, bleed the system of air.





1. Fill brake reservoir with brake fluid. Use SAEJ17O3 or FMVSS No.116 DOT 3
2. Bleed Anti-Lock Brake System (ABS) & Traction Control (TRAC) actuator.

(a) Remove the reservoir cap.





(b) Install the Special Service Tool (SST) # 09992-00241, 09992-00350 to the reservoir.
(c) Connect the vinyl tube to the ABS & TRAC actuator, and loosen the bleeder plug.
(d) Using SST, apply pressure to the reservoir.





(e) Bleed the air out of the ABS & TRAC actuator, tighten the bleeder plug to 8.3 Nm (85 kg.cm, 74 inch lbs.)
3. Check the fluid level and add fluid if necessary. Use SAE J1703 or FMVSS NO.116 DOT3